NABAKEM CLC-30(COLOR LEAK CHECK)
NABAKEM CLC-30(COLOR LEAK CHECK)
  • Load image into Gallery viewer, NABAKEM CLC-30(COLOR LEAK CHECK)
  • Load image into Gallery viewer, NABAKEM CLC-30(COLOR LEAK CHECK)

NABAKEM CLC-30(COLOR LEAK CHECK)

Regular price
RM2,620.00 MYR
Sale price
RM2,620.00 MYR
Regular price
Sold out
Unit price
per 

CLC-30

Description
  • Very fine defect may be detected.
  • Defects found easily with naked eyes.
  • Color is changed(Yellow→Blue)
  • No harmful for paint or metal.
Features & Benefits
Uses & Applications
  • Leakage of various pressure resistant piping may be detected.
  • Gas tank, LPG tank, LNG tank etc.
    How To Use


    • Pretreatment of tested surface
        a) Remove oil content, moisture and alkaline materials, if necessary.
        b) Especially if alkaline materials are adhered, flush tested surface with copious quantities of water and clean it with air or dustcloth.
      Then dry it.

    • Ammonia gas fillup
        a) Input ammonia gas into airtight tank or piping to make ammonia gas 
      concentration 0.01~1% in terms of weight ratio. 
      Explosion range of ammonia gas combined with air is 15~28%, showing its concentration is safe.
        b) High pressure inside tank makes detection sensitivity good. 
      But influence of pressure is not that remarkable. Therefore, inpsection should be done at the pressure (several mmHg~several tens of mmHg) slightly higher than atmospheric pressure.
        c) Time of gas fillup and hold back should be over five minutes.

    • Application of detection agent
        a) As powders of CLC-30 are dispersed in volatile solvent, shake its container till stirring bead is shaked well with clatter.
      Then spray it evenly in the air before use.
        b) Spray it evenly and thinnly to the surface of detected object. Thin film shortens detection time.

    • Inpsection
        a) Leakage points are changed from yellow to blue normally within 5∼10 minutes.
        b) Large leakage points shows large indication shape.
        c) Re-inpsection for about 30~60 minutes is required for sufficient detection of fine leakage points.

    • Post-treatment
      Detection agent film after inspection is easily removed by dustcloth or wire brush.
        a) Mechanical removal by dustcloth or brush
        b) Flushing by pressure water
    Packging
    • 420ml x 20cans